⚓🚤 Extra-Thick Ribbed Boat Fenders for Scratch-Free Docking – Get 6.5 ft Lines & Pump FREE
⚓🚤 Extra-Thick Ribbed Boat Fenders for Scratch-Free Docking – Get 6.5 ft Lines & Pump FREE
BUNDLE & SAVE
Couldn't load pickup availability
Safe & Secure Checkout
256-bit SSL encryption
protects every order.
30-Day Guarantee
Love it or get a full refund.
No hassle.
⚓🚤 Extra-Thick Ribbed Boat Fenders for Scratch-Free Docking – Get 6.5 ft Lines & Pump FREE
One wake is all it takes.
You’re easing up to the gas dock when a wake rolls through. The bow lifts, the hull swings, and fiberglass meets piling before anyone can grab a line.
- The little round fender from the dealer spins out and drifts off down the dock.
- Someone’s wrestling a line onto the rail while the wind pushes you in.
- The bargain fenders you bought online went soft by July.
- Then the fiberglass shop quotes $300 to blend one scratch.
Hang two of these between your hull and the dock, and the post hits thick vinyl instead of your gelcoat.
- 3.8 mm PVC wall
- Raised ribs
- Eyes on both ends
- 6.5 ft lines + pump
Built to take the hit.
Read enough fender reviews and the same complaints keep coming up: pinholes, split seams, fenders that won’t stay put. We picked these with exactly that in mind.
- 3.8 mm marine-grade PVC wall. Thick enough for a hard landing, not just a gentle bump.
- Raised ribs. They grip the hull and help the fender stay where you hung it when the boat surges.
- Reinforced molded eyes at both ends. Hang it vertical or level, whatever the dock calls for.
- UV and saltwater resistant. Built for sun, spray and boat cleaners, in fresh water or salt.
Two eyes. Two ways to hang.
Flat dock or seawall: hang it vertical from one eye.
Pilings: tie a line to each eye and hang it level. The post lands on the middle of the fender, so it doesn’t roll off the side the way a single round fender does.
- Hang your fenders before you start your approach, not while the wind is pushing you in.
- At a floating dock, set them just above the waterline.
- Rinse them with fresh water now and then. Grit stuck to a fender is what scuffs gelcoat.
Find your size in 10 seconds.
Match the fender to your boat’s length. Between two sizes, or docking somewhere rough? Go one size up. You’ll never regret a fender that’s a little too big.
Ready to hang the day it arrives.
No second trip to the marine store for rope. Every fender comes with its own 6.5 ft line, longer than the usual 5 ft, so you can still get the height right at a tall fixed dock.
- 2 ribbed fenders in your size
- 2 × 6.5 ft fender lines
- Hand pump
- 2 inflation needles
| Typical fender | This set | |
|---|---|---|
| Fender lines | Often sold separately | 2 × 6.5 ft included |
| Line length | Usually 5 ft | 6.5 ft |
| Pump & needles | Bring your own | Included |
Hanging level at pilings takes a line at each eye. A second set gives you the extra lines.
Firm, not rock-hard.
Setup takes a few minutes. Thread a needle onto the pump, pump until the fender is firm and round, then press the side with your thumb. It should give about ¼ inch.
Why not pump it hard? A rock-hard fender passes the hit straight to your hull instead of soaking it up.
Every inflatable fender loses a little air over a season, more when temperatures swing. Give them a thumb test now and then and top off in a minute. At the end of the season, let the air out and stow them under a seat.
Before you order
Will black fenders mark my white hull?
These are smooth vinyl, not black rubber, and plenty of boaters run black vinyl fenders on white hulls with no color transfer. What really scuffs gelcoat is grit trapped between the fender and the hull, so rinse them now and then. Bonus: black hides dock grime between washes.
Will they hold air?
Yes. Like every inflatable fender, they lose a little air over a season, more with big temperature swings, so give them a thumb test now and then and top off with the included pump. If one won’t hold air when it arrives, contact us right away.
Can I hang them level instead of vertical?
Yes. Tie a line to each eye and hang the fender level. That’s the right way to fend off pilings. Each set comes with one line per fender, so hanging level takes a second line for each. A second set covers it.
Fresh water or salt?
Both. The vinyl resists UV and saltwater. After a day in salt water, a fresh-water rinse keeps them clean.
Will they work on my pontoon?
Yes. Tie them to a deck cleat or rail post so they sit where your deck edge meets the dock. Pontoons are heavy and flat-sided, so many owners size up. 6.3 × 23 in is the usual pick.
What if I’m not sure about the size?
Send us your boat’s length and model before you order and we’ll point you to the right size. And if it still isn’t right when it arrives, returns are easy.
The gas dock is packed, and the wind just picked up.
Fenders out, lines on, and you slide in like you’ve done it a hundred times. No crunch. No scramble. No repair bill.
Get your set ↑- ✓ Secure checkout
- ✓ Easy returns
- ✓ Email support